Check the hoses: Set the programme selector to "Off". Possible causes: a drain hose is clogged or kinked the siphon connection is sealed the pump cover is not on properly the sewage pump is blocked.
Dishwasher control board test code#
This dishwasher error code indicates a fault with the dishwasher waste water pump. The dishwasher filter system is soiled or clogged. The appliance reports an error with the rinsing circuit, which could be caused by a fault in the circulating pump. This generally involves a fault in the dispenser. Make sure there are no kinks in the water hose. Please check the water inlet, and also see the information on “Dishwasher water supply”. It is also possible that the filter is clogged at the water inlet. The cause may be a bent supply hose, or a closed, jammed or calcified water tap. The appliance has detected a fault in the water inlet. This fault can only be remedied by an experienced engineer. If the problem occurs frequently the appliance probably has a fault. Check the water inflow (make sure the corner valve flow-through and inlet hose are not kinked). Turn off tap.Ī fault has been detected in the filling system or the water inflow. The dishwasher signals that water is in the floor tub. Check the water inflow and make sure the corner valve flow-through and inlet hose are not kinked. Your dishwasher has a problem with water, as indicated by the Siemens dishwasher error code E14. The appliance has activated the water protection system because there is a fault in the filling system or a faulty water supply has been detected. More information about cleaning your dishwasher can be found in the dishwasher guide. Please descale the dishwasher following the descaling instructions. The dishwasher’s heating element is calcified or soiled. There is a fault in the dishwasher’s heating system.Į10 means there is a fault in the dishwasher’s drying system. It could also be that the dishes are covering the water intake opening in the interior so that the water flow is restricted. If bowls or pots have tipped over and water has collected in them, there may be too little water in the appliance for the rinsing process. The dishwasher reports that the water level in the rinse bath is too low and the water level is too low. There is a fault in the dishwasher’s drying system. The dishwasher has detected a faulty door sensor or faulty electronics. If the dishwasher error code is still there, close the water tap and disconnect the dishwasher from the power supply. To do this, please switch off the appliance using the on/off switch, wait a few minutes, then restart the appliance. Solution: Before you contact Siemens Service, restart your dishwasher. This probably means a technical error has occurred or the programme has been interrupted. Your dishwasher is showing a dishwasher error code relating to faulty electronics. In the following overview you can find possible causes of malfunctions and helpful information for rectifying them.
This ensures that the appliance is quickly available to you again. Experience has shown that you can rectify most faults which occur in daily operation yourself.